Harnesses should be designed so that coaxial/fiber optic cables are located at or near the bundle center to minimize flexure and to provide additional protection.Ĭoaxial cable (flexible, semi-rigid, rigid) and fiber optic cables shall exhibit a neatly organized layout, with smooth bends and sufficient stress relief.Ĭonnectors shall be straight, right-angle or flange-mount. Often the most overlooked and ignored component of any electrical/electronic design, cable and harnesses are essential to the accurate and rapid transmission of data and control signals.Ĭonnector backshells shall be potted and molded, or use stress relief boots as required, in accordance with applicable engineering documentation.Ĭables and harnesses shall not be subjected to bending forces resulting in radii less than the minimum specified for the most sensitive component (i.e.: coaxial, fiber, etc.) in the assembly. CABLE AND HARNESS GENERAL REQUIREMENTS CABLE AND HARNESS
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |